Sharp XL-UH12H Setting the clock Remote control only, E-11, Timer playback, To readjust the clock

Setting the clock (Remote control only)

In this example, the clock is set for the 24-hour (00:00) display.

1Press the ON/STAND-BY button to turn to stand-by mode.

2Press and hold the (TIMER)/CLOCK button until “00:00” appear.

3Within 10 seconds, press the or button to adjust the hour and then press the MEMORY button.

Press the or button once to advance the time by 1 hour. Hold it down to advance continuously.

4Press the or button to adjust the minutes and

then press the MEMORY button. Press the or button once to advance the time by 1 minute. Hold it down to advance continuously.

To confirm the time display:

[When the unit is in the stand-by mode]

Press the (TIMER)/CLOCK button. The time display will appear for about 5 seconds.

[When the power is on]

Press the (TIMER)/CLOCK button. The time display will appear for about 5 seconds.

Note:

The “00:00” will appear when the AC power supply is restored after a power failure or unplugging the unit. Readjust the clock as follows.

To readjust the clock:

Perform “Setting the clock” from step 1.

Timer and sleep operation (Remote control only)

Timer playback:

The unit turns on and plays the desired source (CD, USB, TUNER or AUDIO IN) at a preset time.

■Timer playback

Before setting timer:

1Check that the clock is set to the correct time (refer to page 10).

If it is not set, you cannot use the timer function.

2For timer playback, load the disc to be played back.

1Press ON/STAND-BY button to turn the power on.

2Press and hold (TIMER)/CLOCK button for about 2 seconds.

3Within 10 seconds, press the or button to select “ONCE” or “DAILY” and then press the MEMORY button.

4Press the or button to set hour then press the MEMORY button.

5Press the or button to set minute and then press the MEMORY button.

6Press the or button to set hour and then press the MEMORY button.

7Press the or button to set minute and then press the MEMORY button.

8Press the or button to select wake up source (CD, USB, TUNER, AUDIO IN) then press the MEMORY button.

When you select TUNER, select a preset station by

pressing the or button, and then press the MEMORY button. If a station has not been programmed, timer setting will be canceled.

E-11