Sharp XLDH259P operation manual Enhancing your system, E-13, Q Sleep operation, Q Headphones

Timer and sleep operation (Remote control only) (continued)

QSleep operation

The radio, compact disc, iPod and USB can all be turned off automatically.

1Play back the desired sound source.

2Press the SLEEP button.

3Within 10 seconds, press the SLEEP button repeatedly to select the time.

10 20 30 80 90

4“SLEEP” will appear.

5The unit will enter the power stand-by mode automatically after the preset time has elapsed. The volume will be turned down 1 minute before the sleep operation finishes.

To confirm the remaining sleep time:

1While “SLEEP” is indicated, press the SLEEP button.

To cancel the sleep operation:

Press the ON/STAND-BY button while “SLEEP” is indicated. To cancel the sleep operation without setting the unit to the stand-by mode, proceed as follows.

1While “SLEEP” is indicated, press the SLEEP button.

2Within 10 seconds, press the SLEEP button repeatedly to select “SLEEP 00”.

QTo use timer and sleep operation together

Sleep and timer playback:

For example, you can fall asleep listening to the radio and wake up to CD in the next morning.

1Set the sleep time (see above, steps 1 - 5).

2While the sleep timer is set, set the timer playback (steps 2 - 9, page 12).

Sleep timer setting Timer playback setting				End time
	90 minutes		Desired time
	Sleep operation will	Timer playback start
	automatically stop	time

Enhancing your system

The connection cord is not included. Purchase a commercially available cord as shown below.

Portable audio player, etc.

Audio cable

(not supplied)

MICRO COMPONENT SYSTEM

QListening to the playback sounds of portable audio player, etc.

1Use a connection cord to connect the portable audio player etc. to the AUDIO IN jack. When using video equipment, connect the audio output to this unit and the video output to a television.

2Press the ON/STAND-BY button to turn the power on.

3Press the AUDIO IN button on the remote control or FUNCTION button repeatedly on main unit to select AUDIO IN function.

4Play the connected equipment. If volume level of the connected device is too high, sound distortion may occur. Should this happen, lower the volume of the connected device. If volume level is too low, increase the volume of the connected device.

Note:

To prevent noise interference, place the unit away from the television.

QHeadphones

ODo not turn the volume on to full at switch on and listen to music at moderate levels. Excessive sound pressure from earphones and headphones can cause hearing loss.

OBefore plugging in or unplugging the headphone, reduce the volume.

OBe sure your headphone has a 1/8" (3.5 mm) diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms.

OPlugging in the headphone disconnects the speakers automatically. Adjust the volume using the VOLUME control.

E-13