Sharp XR-32S-L Adjust the projected image with the Setup Guide, Correct trapezoidal distortion

4.Adjust the projected image with the Setup Guide

1After the projector turns on, the Setup Guide appears. (When “Setup Guide” is set to “On”. See page 44.)

2Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.

3After adjusting the focus, height (angle) and picture size, press ENTER to finish the Setup Guide.

_PP. 26, 27

5. Correct trapezoidal distortion

Correcting trapezoidal distortion using Keystone Correction.

On the projector

Shrinks	Shrinks
upper side.	lower side.

On the remote control

_P. 28

6. Select the INPUT mode

Select the “COMPUTER” using INPUT on the projector or COMPUTER on the remote control.

On the	On the remote	INPUT list			On-screen display (RGB)
projector	control
			INPUT
						COMPUTER
			COMPUTER			RGB
				*		1024 ⋅ 768

DDVI-D Computer

DDVI-D Video

*XR-32X only

•When you press INPUT on the projector, the INPUT list appears. Press '/" to switch the INPUT mode.

_P. 29

7.Turn the computer on

8.Turn the power off

Press STANDBY/ON on the projector or STANDBY on the remote control, and then press the button again while the confirmation message is displayed to put the projector into standby mode.

On the	On-screen display
	On the remote
projector	control

_P. 25

Quick Start

17