Amplifier, Power ON/STANDBY, Sound Control

ENGLISH

AMPLIFIER

POWER ON/STANDBY

press the POWER button on the receiver or the remote control to turn the power on.

–The receiver enters the operating mode, the respective indicators light up and the standby indicator lights off. To switch the receiver off, press the POWER button again.

–The receiver enters the standby mode and the standby indicator lights up.

in the standby mode, the receiver is not disconnected form the AC mains and a small amount of current is retained to support the memorized contents and operation readiness.

–If the electricity fails or the AC cord is leaved unplugged for more then 2 weeks, the memorized contents are all cleared

System power on/off using the remote control.

If the power switch of the component connected by the DIGI LINK II or III is kept pushed and Its AC cord is plugged in the SWITCHED OUTLETS, each time the POWER button on the remote .control is pressed, Its power is turned on or off Under the same conditions, if Its AC cord is not plugged only in the SWITCHED OUTLET, when the receiver becomes the standby mode, only its display is off.

SOUND CONTROL

Volume

Adjust the overall volume with the MASTER VOLUME control.

Balance

Adjust the stereo balance between the left and the right channels with the BALANCE control.

Treble

Adjust the high tones with the TREBLE control.

Bass

Adjust the bass tones with the BASS control.

WARNING : Extreme settings at high volume may damage your speakers!

Use the SURROUND MODE button to select the desired sound effect: DOLBY PRO LOGIC, DOLBY 3 STEREO, THEATER, HALL or SIMULATED

Press MUTE on the remote control if you want to silence the speakers temporarily.

The volume indicator blinks.

Press again to restore the same listening level as before.

INPUT SELECTION

Selected the desired on the receiver or the remote control.

–The selected input will appear on the display.

–Each time INPUT SELECTOR is rotated, the input is selected as follow;

TUNERCDAUXVCR1 VCR2 PHONO

–When the TAPE MONITOR button is set to on so that "TAPE M"indicator lights up, other inputs can not be heard from the speakers.

To listen to a input other than TAPE MONITOR, be sure to set the TAPE MONITOR button to off.

TAPE 2 MONITOR function

you can connect either a cassette deck or a graphic equalizer to the receiver's TAPE MONITOR jacks.

Only when you listen to the component to there jack, set the TAPE MONITOR button to on.

If you connect a 3-head cassette deck, you can listen to the sound being recorded during recording not the source sound.

For further details, refer to the operating instructions of the component connected.

SURROUND MODE

With the SURROUND MODE button you can select 5 different surround modes: DOLBY PRO LOGIC, DOLBY 3

STEREO, THEATER, HALL, SIMULATED or OFF.

DOLBY PRO LOGIC : choose this setting to play back movies and music (especially Laser Discs, video cassettes and TV broadcasts with DOLBY SURROUND sound). Not only does Dolby Pro Logic surround provide you with sound, it also gives you a clear perception of the position and direction of the sound. Make sure your 'Speaker Positioning' is correct. (see 'INSTALLATION')

With a great number of recently made movies, the sound track is specially encoded with the Dolby Surround mode

carrying the DOLBY STEREO or DOLBY SURROUND trademark. The front speakers provide the dialogue and the normal stereo effect, while the rear speakers reproduce the surround signals. This position provides excellent results when watching television programs, video software, video discs or video tapes of stereo television broadcasts encoded with Dolby Surround.