Sherwood RV-4060R manual Installation, Speaker Positioning, English

ENGLISH

INSTALLATION

SPEAKER POSITIONING

14. VIDEO IN/OUT

–VCR 1 IN/OUT – PLAY(input) and REC(output) jacks for connecting the video output and input of a VCR.

–MONITOR OUT – output jack for connecting to the video input of a TV set. The TV set must then be switched to that input.

15. SUBWOOFER – output jacks for driving subwoofer. Connect this jack to SUBWOOFER input jack of a separate amplifier or a powered SUBWOOFER.

16. DIGI LINK III SYSTEM CONTROL

(colored green) – remote control jacks for connection to the corresponding DIGI LINK II or III jacks of a Sherwood CD (Compact Disc) or tape player.

Connect this jack to the DIGI LINK III jack of the external Sherwood equipment that uses the DIGI LINK II or III remote control system.

These jacks have been added to maintain compatibility with other Sherwood products.

17. REAR SPEAKERS

Terminals for connecting a pair of rear speakers, impedance of 4 Ω each, to obtain a surround sound effect.

Note : Always connect two speakers to these terminals.

18. CENTER SPEAKER

Terminals for connecting a center speaker, impedance of 8 Ω .

19. FRONT SPEAKERS

Terminals for connecting a pair of main speakers, impedance of 8 Ω (L = left, R = right).

One of the wires of a speaker cable is marked with a color or rib. Connect the marked wire to the red terminal, the non-marked wire to the black one.

POWER

10. AC POWER CORD

Connecting the receiver to the wall socket.

11.OUTLET

-Switched output for connecting AC power plugs from various units such as cassette deck, CD player, etc. (Maximum total capacity is 1 A or 100 W)

Power off mode : Switched AC outlet off

Power on mode : Switched AC outlet on

CONNECTING HEADPHONES
Connect a headphone with a 1/4"	PHONES
plug to the PHONES jacks.	MEMO
– Inserting the plug will not
disconnect the speakers.
– Only in surround off mode, you
can enjoy private listening with a
headphone.

SPEAKER POSITIONING

To obtain the best surround sound effect in your home, place the speakers as shown below.

The left and right speakers should be about 1 m (40") from the TV set.

The center speaker should be above or below the TV set. The rear speakers should be placed 2~3 feet above the ear level of a seated listener on the direct left and right of them. Refer to the fold-out for additional information.

	TV
LEFT	RIGHT
	CENTER
	SPEAKER
SURROUND	SURROUND
LEFT	RIGHT

Note : to avoid interference with the TV picture, use only magnetically shielded front speaker systems.

After making all necessary connections (some may not apply to your system set-up), your system is ready for use. In the next chapter, we will describe how to operate your RV-4060R receiver.

4