6. To mute the sound.
•“MUTE” lights up and flickers.
•To resume the previous sound level, press this button again.
7. To listen with the headphones.
•Be sure to switch off both A and B speakers.
Adjusting the tone(bass and treble)
8. Enter the tone mode.
•Each time this button is pressed, the corresponding tone mode is selected and shown for 3 seconds as follows:
→ BASS → TRBL
■Note:
•When the tone direct function is activated, the tone mode cannot be entered and “TON DIR” flickers for 3 seconds.
9. At the desired tone mode, adjust the tone as desired.
•If the tone display disappears, start from the step 8 again.
•When pressing the TREBLE UP/DOWN(∧/∨ ) or BASS UP/DOWN(∧/∨) buttons, you need not select the desired tone mode on the step 8.
■Notes:
•Extreme settings at high volume may damage your speakers.
•In general, the bass and treble levels are adjusted to 0.
10. To listen to a program source without the tone effect.
•“TON DIR” is displayed, “DIRECT” lights up and the sound that bypasses the tone circuitry will be heard.
•To cancel the tone direct function, press this button again to display “TON CTRL”, and then "DIRECT" goes off.
11
