Sherwood RX-770 manual Adjusting the sound volume balance

	To mute the sound.						To listen with the headphones.
6	B					7	PHONES
	TREBLE	+		BASS
				+
	T/P			MUTE	MUTE
			VOL.
	TUNE		MEMO	TUNE
				+
	FM MODE		VOL.	P.SCAN
“MUTE” lights up and flickers.
To resume the previous sound level, press this button						Be sure to switch off both A and B speakers.
again.
Adjusting the tone(bass and treble)							At the desired tone mode, adjust the tone
	Enter the tone mode.					9	as desired.
8							TREBLE	+	BASS
			TONE				T/P		MUTE+	BASS
							or		TREBLE +
								VOL.		+
									UNE
							TUNE	MEMO	T +
							FM MODE	VOL.	P.SCAN
						If the tone display disappears, start from the step 8
Each time this button is pressed, the corresponding						again.
tone mode is selected and shown for 3 seconds as						When pressing the TREBLE UP/DOWN(+/-) or
follows:						BASS UP/DOWN(+,-) buttons, you need not
	BASS	TRBL				select the desired tone mode on the step 8.
						Notes:
Note:						Extreme settings at high volume may damage your
When the tone direct function is activated, the tone						speakers.
mode cannot be entered and “TON DIR” flickers						In general, the bass and treble levels are adjusted
for 3 seconds.						to 0.

To listen to a program source without the tone effect.

1 0

TONE DIRECT

“TON DIR” is displayed and the sound that bypasses the tone circuitry will be heard.

To cancel the tone direct function, press this button again to display “TON CTRL”.

Adjusting the sound volume balance

Enter the balance mode.

1 1

BALANCE

“BAL” and the balance level is displayed for 3 seconds.

Adjust the sound volume balance between 1 2 the left and right speakers.

If the balance display disappears, start from the step 11 again.

Note:

In general, the balance level is set to 0.

1 1