4.Install a Sherwood regulator support handle (p/n TL113) into one of the
the support handle and a 15" adjustable wrench or bench vise to loosen the yoke nut 9 from the body 13 . See Photo #1.
Photo #1
5.Remove the yoke 10 and yoke nut 9 from the body.
6.Use a 5/32" Allen wrench to remove all remaining port plugs 12 16 from the body.
7.Use the Sherwood regulator support handle and a 15" adjustable wrench or a bench vise to remove the cap 26 from the main body. If the regulator is an Oasis or Blizzard model, the trim ring 28 will slide off at this time.
8.Remove the spring 19 , any shims 20 , and the piston assembly 23 from the cap. Remove both piston
9.Remove the piston seat 22 by pushing through the stem with the Sherwood piston seat removal tool (p/n TL112) from the large end. The seat will then pop out. Discard the old seat.
10.Using a 3/32" Allen wrench, remove the flow control element assembly 18 from inside the large end of the main body. There are two styles of flow control assemblies. The old style with a sintered stainless steel flow restrictor and the new style flow restrictor that is laser drilled P/N
NOTE: If a Sherwood DIN adapter (p/n SAA5300)is installed in place of the normal yoke assembly, remove it at this time. See Sherwood Scuba Technical Bulletin #104 for servicing procedures for the SAA5300 DIN adapter.
7
