Adjusting Throttle Level Free Play T272/T272X
The throttle lever free play should be approximately 9/32 inch (7mm). See Figure 7. Make sure that the throttle lever operates smoothly without bind- ing. If it becomes necessary to adjust the lever free play, follow the proce- dures and illustrations that follow.
1. Loosen the lock nut on the cable adjuster. See Figure 6.
2. Turn the cable adjuster in or out as required to obtain proper free play of 9/32 inch (7mm). See Figure 7.
Locknut
�����
9/32 inch |
| |
(7 mm) | Cable | |
Throttle Lever | ||
Adjuster | ||
Free Play | ||
|
ASSEMBLY
3. Tighten the locknut.
Figure 6
Figure 7 |
Assembly and Adjustments
Cutting Attachment Shield T272/T272X
Install the Cutting Attachment Shield.
1.Insert the cutting attachment shield between the outer tube and the cutting attachment mounting plate. See Figure 8.
NOTE:
It may be necessary to loosen the retaining nut and clamp screw to adjust cutting attach- ment shield mounting plate.
2.Fit the two shims and the bracket over the outer tube and loosely install the four
CAUTION!
Make sure the clamp screw and retaining nut are securely tightened before tightening the four socket head cap screws.
3. Tighten the four |
screws to secure the cutting attach- |
Socket- |
|
|
|
|
Head Cap |
|
|
|
|
Screw |
|
|
|
|
|
| Outer |
| |
|
| Tube |
| |
Bracket |
|
|
| Cutting Attach- |
|
|
| ment Shield | |
|
|
|
| |
Shim |
|
|
|
|
Clamp Screw |
|
|
| Nuts |
|
|
|
| Line Cutter |
|
|
| Shim |
|
| Cutting |
|
|
|
Retaining | Attachment |
|
| |
Mounting |
|
| ||
Nut | Hex |
| ||
Plate |
|
| ||
|
| Screws | Figure 8A | |
Figure 8 |
|
| ||
|
|
| ||
|
|
|
| |
ment shield. |
WARNING!
NEVER operate the T272 or T272X without the cutting attachment shield installed and tightly secured!
The line cutter can be positioned in 2 positions to obtain different line length for cutting.
WARNING!
The line cutter is very sharp. Wear gloves to protect your hands when handling.
To Change Position of Line Cutter.
1.Remove the 2 hex screws with a 4mm hex wrench. See Figure 12A.
2.Rotate line cutter. See Figure 12A.
3.Reinstall the two hex screws and tighten them securely.
NOTE:
Be careful to not lose the 2 nuts in the cut- ting attachment shield.
6
