12
Ignition OFF (O)
Cool the engine by allowing it to idle for 2–3 minutes.1.
Move the ignition switch to the “O” or STOP position.2.
Stopping the engine
Cable adjustor
Locknut
Throttle cable
Throttle lever free play
5-7 mm (0.2-
0.275”)
Throttle free play adjustment
If the unit does not return to idle speed or doesen’t reach full rpm, the throttle lever free play may need to be adjusted as
follows:
Measure free play at the end of the 1. throttle lever. Throttle lever free play should be approximately 5-7 mm (0.2-0.275”).
If adjustment is necessary, remove the air cleaner cover by loosening the two thumbscrews. Loosen the cable adjuster lock nut 2. and turn the cable adjustment tting in or out until throttle lever free play is approximately 5-7 mm (0.2-0. 275”).
Replace the air cleaner cover, and tighten the cover retaining screws securely.3.
Operation
Squeezing the throttle increases engine speed, causing the clutch to engage and ■operate the cutters.
Releasing the throttle decreases engine speed, causing the cutters to slow, and
■then stop altogether as the clutch disengages.
Use a sweeping motion when cutting, and vary throttle settings often.
■
Avoid cutting material larger than 1.27 cm in diameter. ■
Always grip support handle with right hand and throttle handle with left hand. ■