Shindaiwa EB344EF13 manual Exhaust System, Carburetor Adjustment, Spark Arrester Maintenance

Models: EB344EF13 X7501930200

1 28
Download 28 pages 57.29 Kb
Page 17
Image 17
Exhaust System

Exhaust System

Spark Arrester Maintenance

WARNING!

Never operate this blower with a damaged or missing muffler or spark arrester! Operating with missing or damaged exhaust components is a fire hazard, and can also damage your hearing!

Hard starting or a gradual loss of performance can be caused by carbon deposits lodged in the spark arrester screen. For maximum performance, the spark arrester screen should be periodically cleaned as follows. See Figure 16.

1.Remove engine cover to expose muffler. Remove the spark arrester from the muffler. The screen is press-fit in place.

2.Remove screen from cover.

3.Use a plastic scraper or wire brush to remove carbon deposits from the arrester screen and wipe clean exhaust base.

4.Inspect the screen carefully, and replace any screen that has been perfo- rated, distorted, or is otherwise unserviceable.

5.Press the spark arrester screen into the arrestor cover.

If carbon accumulation in the muffler or cylinder are severe, or if you do not notice an improvement in performance after servicing, have the unit inspected by an authorized servicing Shindaiwa dealer.

Carburetor Adjustment

Engine Break-In

New engines must be operated a minimum duration of two tanks of fuel break- in before carburetor adjustments can be made. During the break-in period your engine performance will increase and exhaust emissions will stabilize. Idle speed can be adjusted as required.

High Altitude Operation

This engine has been factory adjusted to maintain satisfactory starting, emis- sion, and durability performance up to 1,100 feet above sea level (ASL) (96.0 kPa). To maintain proper engine operation and emission compliance above 1,100 feet ASL the carburetor may need to be adjusted by an authorized Shin- daiwa service dealer.

IMPORTANT!

If the engine is adjusted for operation above 1,100 feet ASL, the carburetor must be re-adjusted when operating the engine below 1,100 feet ASL, other- wise severe engine damage may result.

NOTE:

Every unit is run at the factory and the carburetor is set in compliance with emis- sion regulations. Carburetor adjustments, other than idle speed, must be per- formed by an authorized Shindaiwa dealer..

Arrester Screen

Cover

 

Arrester

Muffler

Figure 16

Screen

 

17

Page 17
Image 17
Shindaiwa EB344EF13, X7501930200 manual Exhaust System, Carburetor Adjustment, Spark Arrester Maintenance, Engine Break-In