Mixing Instructions

1.Fill an approved fuel container with half of the required amount of gasoline.

2.Add the proper amount of engine oil to gasoline.

3.Close container and shake to mix oil with gasoline.

4.Add remaining gasoline, close fuel container, and remix.

IMPORTANT!

Spilled fuel is a leading cause of hydrocarbon emissions. Some states may require the use of automatic fuel shut-off containers to reduce fuel spillage.

After use

DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel storage container.

Storage - Fuel storage laws vary by locality. Contact your local govern- ment for the laws affecting your area. As a precaution, store fuel in an ap- proved, airtight container. Store in a well-ventilated, unoccupied building,

away from sparks and flames.

IMPORTANT!

Stored fuel may separate. ALWAYS shake fuel container thoroughly be- fore each use.

Filling the Fuel Tank

1.Place the blower on a flat, level surface.

2.Clear any dirt or other debris from around the fuel filler cap. 3.Remove the fuel cap, and fill the tank with clean, fresh fuel. 4.Reinstall the fuel filler cap and tighten firmly.

5.Wipe away any spilled fuel before starting the blower.

Starting the Engine

WARNING!

Danger from rotating impeller!

The impeller will rotate whenever the blower is operated! Never operate this blower unless the intake cover and blower tubes are properly installed and in good working order!

WARNING!

Danger from thrown dust or debris!

Always wear eye protection when operating this machine! Never direct the blower stream toward people or animals!

Never operate this blower unless all controls are properly installed and in good working order.

CAUTION!

The recoil starter can be damaged by abuse!

Never pull the starter cord to its full length!

Always engage the starter before cranking the engine!

Always rewind the starter cord slowly!

Never operate the blower if blower tubes are missing or damaged!

Remove the Fuel Filler Cap

Figure 4

Starting Procedure

1.Place the blower on the ground.

2.Prime the fuel system by repeat- edly depressing the fuel primer bulb until no air bubbles are visible in the fuel discharge line.

IMPORTANT!

The primer system only pushes fuel through the carburetor. Repeatedly pressing the primer bulb will not flood the engine with fuel.

Choke

Open

Choke

Closed

Figure 5

3.Cold Engine Only. Choke the engine by moving the choke lever up (choke is closed). See Figure 5.

9

Page 9
Image 9
Shindaiwa EB344EF13, X7501930200 manual Filling the Fuel Tank, Starting the Engine, After use, Starting Procedure