Shindaiwa X7502891200, PS344 Emission Control Exhaust & Evaporative, Assembly, Prior to assembly

Emission Control (Exhaust & Evaporative)

EPA 2010 and Later and/or C.A.R.B. TIER III

The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to California models only.

An Emission Control Label is located on the unit. (This is an EXAMPLE ONLY; information on label varies by en- gine FAMILY).

PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)

The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as listed in the Maintenance Section of this manual.

Assembly

Prior to assembly

Before assembling, make sure you have all the components required for a com- plete unit:

■■PowerBroomUnit

■■Kit with this manual and tool kit for routine maintenance..

■■Carefully inspect all components for damage before assembling.

WARNING!

Do not make unauthorized modifications or alterations to your machine or its components.

IMPORTANT!

Adjustable Handle

This unit comes with the handle installed. It can be re-adjusted for operator comfort in the following manner.

1.Loosen adjustment knob. Locate the handle at the best position for operator comfort (usually about 10 inches ahead of the throttle trigger), and secure it by tightening the adjustment knob at the handle base.

The terms “left”, “left-hand”, and “LH”; “right”, “right-hand”, and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal operation.

Handle

Throttle Assembly

Mounting Screw

Washer

Adjustment Knob

Washer

Hex Nut

Outer Tube

6