Installation
1. Choose a suitable site for the handset unit
Make sure it is not near to another telephone, nor to other electrical equipment.
2.Plug the mains power lead into the power jack
the base unit and plug the telephone line cord into the telephone port.
3.Plug the mains adapter into a 230 V AC, 50 Hz mains socket, with the switch on the socket set to OFF
Note: The illustration of adaptor may vary from country to country.
4.Switch on mains power at the socket
5.Fit the battery in the handset(s)
Insert the battery pack as shown .Fit the battery compartment cover,
Sliding it until it clicks firmly into position.
6. Connect the base unit to the telephone line
Important safety information
This equipment is not designed for making emergency calls in the event of a power failure. Alternative arrangements should be made for access to emergency services.
(This means that you should also have a basic phone that does not need mains power, connected to your line so that you can make calls during a power failure)
People with a heart pacemaker should consult their doctor before using the telephone.
If you wear a hearing aid, you should note SD2100 works by transmitting radio waves between base and handset that may cause a humming noise.
1.DO NOT clean any part of your phone with benzene, thinner or other solvent chemicals, which may cause permanent damage to your phone. This damage is not covered by the Guarantee. When necessary, clean it with a damp cloth.
Cleaning it with a wet cloth may give you an electric shock.
2.DO NOT use this equipment in places where volatile or explosive materials may be present.
3.DO NOT let the base unit get wet. Electrical equipment can cause serious injury if used while you are wet or standing in water. NEVER use your phone during a thunderstorm. Unplug
4
