Shoprider GK9 manual Batteries and Battery Charging, Battery Charger

Models: GK9

1 19
Download 19 pages 28.87 Kb
Page 14
Image 14

BATTERIES AND BATTERY CHARGING

The Shoprider® Start 8 Portable scooter is supplied with maintenance-free, sealed lead acid batteries. For easy handling, the batteries are contained within a battery pack. Battery life and performance may be affected by temperature, terrain, condition of battery, the weight of the user, care of batteries, and other conditions. The battery needle gauge is only a guide and is most effective when the scooter is moving, only then is the true discharge level displayed.

When the scooter stops the battery needle gauge may indicate full.

An active user can use up to 30% of battery capacity or more per day.

Inactive users may only use 50% of battery capacity in a week.

In both these instances the battery should be put on charge over night.

**Keeping the batteries charged at all times will extend the life of the batteries**

Battery Charger

The battery charger is a 3-amp transformer type off board. The Start 8 Portable scooter has a built in charger port on the rear side of the battery pack. This special feature allows the batteries within the battery pack to be charged without the scooter.

First Time Use

Prior to using your Start 8 Portable scooter for the first time, you must charge the batteries fully (refer to Battery Charging Procedures). Charging may take up to 12 hours. Charging the batteries completely prior to first time use will benefit battery efficiency. Failure to do so may cause damage.

Charging

To charge the batteries connect the 3-pin male plug lead into the 3-pin female battery- charging socket located on the battery pack. Plug the A/C cord plug into the wall socket and the other end into the charger (2-pin). The battery charger has two indicator lights. The red light shows the batteries are charging. When the light turns green while connected to the charging port the batteries are fully charged. Once the batteries are completely charged, unplug the A/C cord from the wall then unplug the 3-pin lead from the battery pack. Remove charger once charging cycle is finished.

WARNING: Only use the original Shoprider approved charger!

This charger is for indoor use only. DO NOT expose it to rain or water spray.

Do not leave the charger plugged into the charger port if the charger is not charging.

7/8/2009SE

14

Page 14
Image 14
Shoprider GK9 manual Batteries and Battery Charging, Battery Charger