
LX2 HAND-HELD MICROPHONE TRANSMITTER SETUP
Battery Installation (Figure 11)
1.With the transmitter PWR ON/OFF switch in the OFF position, hold the upper part of the transmitter and unscrew the battery cover.
LX2
FIGURE 11
2.Install a fresh 9V alkaline battery (DURACELL MN1604 recommended). Make sure the battery terminals match the terminals in the transmitter.
3.Replace the battery cover.
Installing the Anti±Roll Device
The rubber
To install the
FIGURE 12
8
Operating the LX2 Hand-Held Microphone Transmitters (Figure 13)
1.Press the POWER switch on the
2.Slide the transmitter POWER ON/OFF switch to the PWR position. Check the bat- tery level. See Checking the Transmitter Battery.
3.Check the RF indicator on the
4.Slide the transmitter ON/MUTE switch to the ON position and begin speaking or singing.
NOTE: If the red PEAK light on the receiver does not flicker during the loud- est sounds, the transmitter gain may need to be increased. See the Trans- mitter Audio Gain Adjustment section.
5.During the performance or presentation, slide the ON/MUTE switch to the MUTE position when the microphone is not being used.
6.When the performance or presentation is over, slide the transmitter POWER ON/OFF switch to the OFF position to conserve battery power.
LX2
TRANSMITTERS
RECEIVER
LX2 HAND±HELD MICROPHONE SYSTEM OPERATION
FIGURE 13
9