Shure SCM410E manual Supplied Hardware, Rack Mounting, Single Mixer Half Rack Installation

INSTALLATION

SUPPLIED HARDWARE

￿	4 rubber feet	￿
￿ 1 rackmount bracket, long		￿
￿ 1 rackmount bracket, short		￿
￿	2 straddle brackets	￿

RACK MOUNTING

10 bracket screws, 6 mm (1/4 in.)

4 rackmount screws, 2.54 cm (1 in.)

4 plastic washers

4 wood screws, 1.25 cm (1/2 in.)

The SCM410 is supplied with hardware for mounting one or two units to a 19-inch audio equipment rack. The hardware can also be used to rack mount other Shure products, including the SCM268, SCM262, DFR11EQ, and the DP11EQ.

Single Mixer (Half Rack) Installation

1.Attach the short and long rackmount brackets to the SCM410/E with eight (8) of the supplied bracket screws, as

shown in Figure 4.

Dual Mixer (Full Rack) Installation

1.Place the two mixers side-by-side and connect them with two (2) straddle brackets. The brackets should straddle the recessed edges on the top and bottom of each mixer. See

Figure 6.

INSTALLING STRADDLE BRACKETS

FIGURE 6

INSTALLING HALF±RACK MOUNTING BRACKETS

FIGURE 4

2.Place the mixer in an equipment rack and secure it with the supplied rackmount screws and plastic washers. See

Figure 5.

RACK MOUNTING A SINGLE SCM410/E MIXER

FIGURE 5

2.Fasten the straddle brackets using eight (8) bracket screws.

3.Attach the short rackmount brackets to the outsides of the combined mixers with eight (8) of the bracket screws. See

Figure 7.

INSTALLING FULL±RACK MOUNTING BRACKETS

FIGURE 7

4.Place the mixer in an equipment rack, using the supplied rackmount screws and plastic washers. See Figure 8.

RACK MOUNTING DUAL SCM410/E MIXERS

FIGURE 8

5