|
| INDICATOR STATUS |
|
| |
PROBLEM | RECEIVER | TRANSMITTER | SOLUTIONS | ||
| ULXS4 | ULX4P | ULX1 | ULX2 |
|
Sound level from the |
|
|
| • Adjust transmitter gain as necessary. | |
receiver is different |
|
|
| • Adjust receiver volume as necessary. | |
from that of a cabled |
|
|
|
|
|
guitar or microphone. |
|
|
|
|
|
Sound level is dif- |
|
|
| • Adjust transmitter gain to compensate for differenc- | |
ferent when you |
|
|
|
| es when you change between guitar output levels. |
change guitars. |
|
|
|
|
|
Distortion increases |
|
|
| • | Replace transmitter battery. |
gradually. |
|
|
|
|
|
Bursts of noise, dis- |
|
|
| • If noise occurs when transmitter is turned off, locate | |
tortion, or other radio |
|
|
|
| and remove nearby RF sources, such as other wire- |
performance. |
|
|
|
| less systems, signals interrupt CB radios, etc. |
|
|
|
| • Change the wireless systems’ operating frequency. | |
Momentary loss of |
|
|
| • Reposition receiver and perform | |
sound as transmit- |
|
|
|
| test. If audio moved around dropouts persist, mark |
ter is moved around |
|
|
|
| “dead” spots and avoid them during performing |
performing area |
|
|
|
| area performance. (dropouts). |
(dropouts) |
|
|
|
|
|
Receiver or Transmit- |
|
|
| • Receiver or transmitter is in Master List mode. To | |
ter LCD displays E000 |
|
|
|
| enter or exit the Master List, press and hold the SET |
or F000 or similar |
|
|
|
| button for approximately 10 seconds or until the dis- |
code instead of the |
|
|
|
| play changes. |
group and channel. |
|
|
|
|
|
LICENSING INFORMATION
Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate the equip- ment. Licensing of Shure wireless microphone equipment is the user’s responsibility, and licensability depends on the user’s classification and application, and on the selected frequency. Shure strongly urges the user to contact the appropri- ate telecommunications authority concerning proper licensing, and before choosing and ordering frequencies.
IMPORTANT!
NOTE: | THIS EQUIPMENT MAY BE CAPABLE OF OPERATING ON SOME FREQUENCIES NOT |
| AUTHORIZED IN YOUR REGION. PLEASE CONTACT YOUR NATIONAL AUTHORITY |
| TO OBTAIN INFORMATION ON AUTHORIZED FREQUENCIES FOR WIRELESS |
| MICROPHONE PRODUCTS IN YOUR REGION. |
Frequency Range of ULX Series: 554 MHz–865 MHz
Licensing: A ministerial license may be required to operate this equipment in certain areas. Consult your national author- ity for possible requirements.
26
