Set volume
End call

Security 9

Security

The phone and SIM card are protected against misuse by several security codes.

Keep these confidential numbers in a safe place where you can access them again if required.

§Menu§ ¢ Setup ¢ Security ¢ Select a function:

PIN control

The PIN is usually requested each time the phone is switched on. You can deactivate this feature but you risk unauthor- ised use of the phone. Some service providers do not permit deactivation of the control.

Change PIN

You can change the PIN to any 4–8 digit number you may find easier to remember.

Change PIN 2

(Displayed only if PIN 2 is available). Proceed as with Change PIN.

Change phonecode

You define and enter the phone code (4–8 digits) when calling a phone code protected function (e.g. Direct call, p. 11) for the first time. It is then valid for all protected functions. If it is entered incorrectly three times the phone is locked. Contact the Siemens Service (p. 27).

Clear SIM card barring

If the PIN is entered incorrectly three times, the SIM card is barred. Enter the PUK (MASTER PIN) provided by your service provider with the SIM card. If the PUK (MASTER PIN) has been lost, please contact your service provider.

Prevent accidental activation

Even if PIN use is deactivated (p. 9) confirmation is required to switch on the phone.

This prevents accidental activation of the phone, e.g. when you are carrying it in a bag or when you are travelling in an air- craft.

After pressing and holding the On/Off/End key Bselect §OK§ to switch on the phone or abort the operation with §Cancel§.

Making a phone call

Dialling with number keys

The phone must be switched on (standby mode). Enter the number (always with

prefix, if necessary with the international dialling code). Press §Clear§ to clear the last

digit, press and hold to clear the entire phone number. To dial press theAkey.

Press the End key Bbriefly. Press this key even if the person on the other end of the line has hung up first.

Use the scroll keyEto start adjusting the volume during conversation. Set volume withG.

If a car kit is used, its volume setting will not affect the usual setting on the phone.

Redial previous numbers

To redial the phone number last called, press the Call key Atwice. To redial other numbers that were dialled previously, pick out the required phone number from the list withG, then press Ato dial.