Chapter 5:Connection Mode
Allow you to remove the selected static route
settings.
Adding a New One
To add a static route, please choose Static Route - Add. Type the destination network address, subnet
mask and gateway that you get from ISP and click Apply.
Destination Network Address:
The destination IP address of the network
where data packets are to be sent.
Subnet Mask:
Type in the subnet mask that you got from
ISP.
Gateway IP Address:
Click this button to invoke this function.
Type in the gateway that you got from ISP.
WAN Interface:
Click this button to invoke this function and
choose the one from the drop down menu.
Click Apply to view the routing result. This page shows all the routing table of data packets going
through your ADSL Router.
Remove Static Route
If you don’t want the static route that you
created, please click the icon under Delete
from Routing Table.
A dialog appears to ask you to confirm the
action. Click Yes to remove the static route,
or click No to keep the setting.
Configuring Other Routers on Your LAN
It is essential that all IP packets for devices that are not on the local LAN can be passed to the Router,
so that they can be forwarded to the external LAN, WAN, or Internet. To achieve this, the local LAN
must be configured to use the Router as the default route or default gateway.
Local Router
The local router is the Router installed on the same LAN segment as the Router. This router requires
that the default route is the Router itself. Typically, routers have a special entry for the default route.
It should be configured as follows.
Destination: Normally 0.0.0.0 but check your router documentation.
Subnet Mask: Normally 0.0.0.0 but check your router documentation.
Gateway: The IP Address of the Router.
Other Routers on the Local LAN
Other routers on the local LAN must use the Router’s Local Router as the Default Route. The entries
will be the same as the Router’s local router, with the exception of the Gateway IP Address.