For a router with a direct connection to the Router’s local Router, the Gateway IP Address is
the address of the Router’s local router.
For routers which must forward packets to another router before reaching the Router’s local
router, the Gateway IP Address is the address of the intermediate router.
Example – Static Route
Here provides you an example of Static Route.
For the Router’s Routing Table
For the LAN shown above, with 2 routers and 3 LAN segments, the Router requires to add 2 static
routes as follows:
ADSL Router Destination 192.168.10.0
Subnet Mask 255.255.255.0 (Standard Class C)
Gateway 192.168.1.254 (Router B)
IP Routing – Dynamic Routing Routing Information Protocol (RIP) is utilized as a means of exchanging routing information
between routers. It helps the routers to determine optimal routes. This page allows you to
enable/disable this function.
RIP Version:
It incorporates the RIP information when
receiving and broadcasting the RIP packets.
From the drop down list, select a RIP version
to be accepted, 1, 2 or both.
Operation Mode:
There are two modes for you to choose,
Active and Passive. Select Active for
transmitting and receiving data, or select
Passive for receiving data only.
Enabled:
Click Enabled to enable the RIP function on