IGWiPS200-1
Changes or modifications not expressly approved by Siemens will void the user’s authority to operate the
equipment.
This product is intended for fixed installation applications. In order to comply with FCC/ISC adopted RF exposure
requirements, installation of this transmitter system’s antenna must be performed in a manner that will provide at
least a six foot (2m) clearance from the front radiating aperture to any user or member of the public.
FCC 47CFR15.247
ISC RSS 210
UL Class I, Div. 2 (Groups A,B,C,D)
CSA HAZARDOUS LOCATION PRECAUTIONS This section provides CSA hazardous location precautions that should be observed by the user when installing or
servicing the equipment described in this Instruction. These statements supplement those given in the preceding
section.
Precautions - English
For Class I, Division 2 hazardous locations:
• Use only factory-authorized replacement parts. Substitution of components can impair the suitability of this
equipment for hazardous locations.
For Division 2 hazardous locations:
• When the equipment described in this publication in installed without safety barriers, the following precautions
should be observed. Switch off electrical power at its source (in non-hazardous location) before connecting or
disconnecting power, signal, or other wiring.
Précautions - Français
Emplacements dangereux de classe I, division 2:
• Les pièces de rechange doivent être autorisées par l'usine. Les substitutions peuvent rendre cet appareil
impropre à l'utilisation dans les emplacements dangereux.
Emplacement dangereux de division 2:
• Lorsque l'appareil décrit dans la notice ci-jointe est installé sans barrières de sécurité, on doit couper
l'alimentation électrique a la source (hors de l'emplacement dangereux) avant d'effectuer les opérations
suivantes branchment ou débranchement d'un circuit de puissance, de signalisation ou autre.
ENVIRONMENTAL CONSIDERATIONS Operate each device within its environmental specifications to help ensure reliable, trouble-free operation with
minimum down time. Refer to the Specifications section for operating temperatures limits, operating humidity, and
maximum moisture content. CAUTION
Exceeding the specified operating temperature limits can adversely affect performance and
may cause damage to the instrument.
May 2007 9