IGWiPS200-1
MOUNTING THE 1/4-WAVE WHIP ANTENNA Mount the 3-1/6" (80.4 mm) high, omnidirectional whip antenna5, shown at right, within 5' (1.5m) of the
transceiver to allow the supplied 6' (2m) cable to easily reach between the antenna and transceiver. A
mounting bracket and three screws are supplied. Antenna spacing (transmitter to receiver) should not
exceed 600' to 1000' (183m to 305m). Line of sight is not a requirement.
Incorrect antenna placement and positioning can have a significant impact on the performance of the
system. Keep the omnidirectional antenna vertical and mounted as high as possible.
1. Fasten the supplied right-angle bracket to a rigid, vibration-free surface such that the antenna is oriented
vertically.
2. Unscrew the black disk from the antenna cable end. Insert the antenna cable stud into the large center hole in
the bracket and thread the disk onto the stud. The shallow shoulder on the disk should be toward the bracket
surface. Refer to the cover of this publication.
3. Center the disk in the hole using the shallow shoulder on the disk to assist centering and then tighten the disk.
The supplied hex wrench can be inserted in a hole in the disk perimeter to help tighten the disk. Do not over
tighten. The threaded stud must not be in contact with the grounded bracket.
4. Thread the antenna onto the stud and tighten.
5. Once the transceiver is installed, plug the MCX male connector on the end of the antenna cable into the MCX
female connector on the transceiver faceplate.
WIRING This section provides wiring guidelines for the transceiver and I/O Expansion modules.
A wireless network contains a master transceiver and up to eight matched remote transceivers. These transceivers
will communicate only with each other. Refer to Installation, Matched Transceivers for additional information.
Before wiring transceivers, confirm that the ID numbers match and that the installed locations are correct. This is
particularly important when installing several wireless networks.
These devices must be wired in accordance with Class 1, Div. 2 wiring methods as described in the National
Electrical Code, Article 501-4(b) or the authority having jurisdiction.
DANGER
Will cause death or injury.
• Remove power from all wires and terminals before working on
equipment.
• In a potentially hazardous atmosphere, remove power from equipment
before connecting or disconnecting power, signal, or other circuit.
• Observe all pertinent regulations regarding installation in a hazardous
area.
5 For other antenna models, refer to the appropriate antenna Data Sheet for specifications and mounting dimensions. Additional
installation information may be provided with the antenna.
May 2007
16