Siemens MCM 1902 FCC Class B Compliance Statement

Color monitor MCM 1902

4 - English A26361-K527-Z100-2-5E19

CEcertificate

Theshipped version of this device complies with the requirements of the EEC

directives89/336/EEC "Electromagnetic compatibility" and 73/23/EEC "Low voltage

directive".

Thisdevice complies with the German X-ray regulations (Röntgenverordnung - RöV). The local

dosageemitted is less than 1 µSv/h(micro-Sievert per hour) at a distance of 0.1m.

FCC Class B Compliance Statement

Ifthere is an FCC statement on the device, then:

Thefollowing statement applies to the products covered in this manual, unless otherwise specified

herein.The statement for other products will appear in the accompanying documentation.

NOTE:

Thisequipment has been tested and found to comply with the limits for a "Class B" digital device,

pursuantto Part 15 of the FCC rules and meets all requirements of the Canadian Interference-

CausingEquipment Regulations. These limits are designed to provide reasonable protection against

harmfulinterference in a residential installation. This equipment generates, uses and can radiate

radiofrequency energy and, if not installed and used in strict accordance with the instructions, may

causeharmful interference to radio communications. However, there is no guarantee that

interferencewill not occur in a particular installation. If this equipment does cause harmful

interferenceto radio or television reception, which can be determined by turning the equipment off

andon, the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorientor relocate the receiving antenna.

• Increasethe separation between equipment and the receiver.

• Connectthe equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consultthe dealer or an experienced radio/TV technician for help.

SiemensAG is not responsible for any radio or television interference caused by unauthorized

modificationsof this equipment or the substitution or attachment of connecting cables and

equipmentother than those specified by Siemens AG. The correction of interferences caused by

suchunauthorized modification, substitution or attachment will be the responsibility of the user.

Theuse of shielded I/O cables is required when connecting this equipment to any and all optional

peripheralor host devices. Failure to do so may violate FCC rules.