49
Transport e.g. when moving
Before transporting the washer-dryer:
- Turn off the water tap,
- Drain any residual washing solution (refer to
Page 32),
- Release the water pressure in the supply hose
(refre to Page 33),
- Disconnect the washer-dryer from the mains,
- Dismantle the supply and drainage hose,
- Install the transport bolts.
- Having transported the appliance and ensured
proper installation and connection, allow the
Draining programme to run through before
starting the first wash programme.
Preparing and insertingthe transport bolts
Remove the covers.
Preparing the transit bolt(see picture: page 44):
Pull the bolt out of the sleeve until the end of the
bolt is flush with the end of the sleeve.
Insert and tighten the bolts.
The lug on the washer must be located in the
groove in the rear panel of the housing.