Sierra Products EF-4001B operating instructions Safety Notice, General Information

EF4001B AutoLite Pellet Stove Insert

Installation & Operating Instructions

Please read this entire manual before installation. Save these instructions.

SAFETY NOTICE

<CAUTION: HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN BURNS.

<IF THIS HEATER IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT.

<CONTACT LOCAL BU ILDING OFFICIALS ABOUT RE- STRICTIONS AND INSTALLATION INSPECTION REQUIRE- MENTS IN YOUR AREA.

<FAILURE TO COMPLY WITH OWNERS' MANUAL IN- STRUCTIONS WILL VOID YOUR WARRA NTY!

NOTE: This heater should not be installed in a bedroom or bathroom.

PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET FUEL-BURNING ROOM HEATER. FAILURE TO FOLLOW T HESE IN STRUCTION S COU LD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH.

GENERAL INFORMATION

Installation and repair should be done by a qualified service person. The heater should be inspected before use and at least annually by a professional service person. More frequent cleaning may be re quired due to fuel quality, excessive lint from carpeting, bedding m aterial, etc . It is impera tive that control com partm ents, burn pot and circulat- ing air passageways of the heater be kept clean.

The EASYFIRE Pellet Insert has been designed and approved for burning wood pellet fuel only. Burning solid fuel in other forms is not permitted and will void all warran- ties.

This unit has been approved for use with a Ø 3" Type L Pellet Vent System or Stainless Chimney Liner (Ø 4" on runs 10 feet and above).

NEVER use gasoline, gasoline-type lantern fuels, kerosene, charcoal lighter fluid, or similar liquids to start or "freshen up" a fire. Keep all such liquids well away from the heater while it is in use.

Ashes must be disposed of in a metal container with a tight fitting lid and placed on a noncombustible floor or ground, well away from all fuels, pending final disposal.

NOTE : During the first few burns the high tem perature paint and sealant used in manufacture will emit some odor and smoke. Open doors and windows to the outside for proper ventilation during the first burn cycle and curing of the paint.

This heater, when installed, m ust be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70-

2006.

INSTALLER: PLEASE LEAVE THIS MANUAL WITH THE OWNER!!

Sierra Products, Inc.
5061 Brooks St., Ste B	Listed by OMNI-Test
Montclair, CA 91763
	Laboratories, Inc.
(909) 399-3355	Report No. 256-S-01-4