Sierra Products UV360FP operating instructions Attaching Optional Trim

Figure 3 - Projection Clearance

FIG. 6 - Optional Remote (MV only)

Figure 4 - Side Projection Clearance

ATTACHING OPTIONAL TRIM

1.Attach the top SS trim piece onto fireplace cabinet by loosening existing (3) #8 Phillips screws, slide trim into place, then tightening down screws.

2.Attach the (2) side SS trim pieces onto the fireplace in the same manner as the top piece. Note: Be sure the angled edges fit against top trim piece.

Figure 5 - Attaching Optional Trim

OPTIONAL REMOTE CONTROL UNIT

Note: Be sure to read the instructions included with remote control unit prior to installing.

1.Install the remote control unit into remote control bracket and using (2)#8 Phillips screws. Be sure that the word "TOP" is on the left-hand side of the unit. Tighten screws to a point where 2-3 threads are visible from the rear of the bracket. This will allow enough clearance for the remote cover to slide onto unit. If unit is loose, tighten screws slightly until unit is snug with cover on. (Fig 6.)

2.Install remote switch onto remote unit.

3.Open hinged lower panel by releasing catch. Attach remote assembly to inside left side of the fireplace. Remote assembly can be secured to wall using (2)#8 Phillips screws ( Fig 7).

Figure 7- Mounting remote face plate

Figure 8 - Control Assembly

4