22
4
5
6
7
1
2
3
LOCK
Program your Opener & Remote
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play near the door.
Your garage door opener receiver and remote control transmitter are set to a matching code. If you purchase additional remote controls, the garage door opener must be programmed to accept the new remote code.
Program the Receiver to Match Additional Remote Control Codes:
Using the orange “LEARN” Button
1.Press and release the orange “learn” button on the opener. The learn indicator light will glow steadily for 30 seconds
(1).
2.Within 30 seconds, press and hold the button on the
3.Release the button when the opener light blinks. It has learned the code. If the light bulb is not installed, two clicks will be heard (3).
Using the Multi-Function Door Control:
4.Press and hold the button on the
5.While holding the remote button, press and hold the LIGHT button on the
6.Continue holding both buttons while you press the push bar on the
7.Release buttons when the opener light blinks. It has learned the code. If the light bulb is not installed, two clicks will be heard (7).
Now the opener will operate when the remote control push button is pressed. If you release the remote control push button before the opener light flashes, the opener has not learned the code.
To Erase all Remote Control Codes
To deactivate any unwanted remote, first erase all codes: Press and hold the orange “learn” button on opener until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.
3-Channel Remote:
If provided with your garage door opener, the large button is factory programmed to operate it. Additional buttons on any rolling code
13
