SIIG 04-0600B manual Concrete Surface

4.With the anchors in place, mount the wall plates using the #12 x 3/4" self tapping screws, see Figure 8 below.

Pre Drill 5/16" Holes

Insert Alligator Anchor

#12 x 3/4" Self

Tapping Screw

Insert screw through wall plate and into the alligator anchor

Figure 8

Concrete Surface

1.Using the wall plate as a template, mark hole positions on the mounting surface. For in-wall applications, position the mounting holes in a vertical pattern, see Figure 9 on the next page.

2.Drill holes in the solid concrete or hollow block using a 5/16" masonry bit. Once the holes are drilled, insert the # 12-14 alligator anchors into the holes and make sure the anchor is flush with the surface of the wall, see Figure 9 on the next page.

10