SIIG 04-0600B manual Key Hole Mounting

5.When the correct size is determined, place the screw through the speaker post and attach to the rear of the speaker enclosure. If the screw does not tighten properly, use the M5 x 1/8" plastic washer to tighten it up.

Key Hole Mounting

1.If your speaker has a factory key hole design, you will use the 8-32 x 5/8" machine screws in combination with the 8-32 Hex Key Hole Nut.

2.Loosely pre-assemble the mounting post with the 8-32 x 5/8" machine screw and hex key hole nut, see Figure 4 below.

Keyhole	Mounting Post
		M5 x 1/8"
		Plastic Washer
Back Speaker			8-32 x 5/8"
			Machine Screw

8-32 Hex Key Hole Nut

Figure 4

5