5.Set JP1 and JP2 jumper settings to the desired voltage only if your serial device needs additional power from the serial port. However, most serial devices do not require additional power. For more information see Figure 1 on page 2. The jumpers can be removed if power is not required.
6.To install the card, carefully align the card's bus connector with the selected PCI slot on the motherboard. Push the board down firmly, but gently, until it is well seated.
7.Replace the slot bracket holding screw to secure the card.
8.Replace the computer cover and reconnect the power cord.
9.Connect the
Driver Installation
This section provides information on how to install the CyberPro PCI 2S drivers.
Windows 95
1.At the Update Device Driver Wizard, click Next.
2.Insert the driver CD, click Other Locations.
3.Type in D:\9x, click OK, then click Finish. (Change D: to match your
4.From the Insert Disk window, click OK. When the Copying Files dialog box pops up, type in D:\9x, then click OK.
5.Restart Windows to complete the installation.
4
