Silicon Optix CM-525P manual View Angle, Horizontal Position

4. PTZ SETUP MENU

D. VIEW ANGLE

Note: When the dome camera is installed near a wall, panning range can be programmed by users.

--- OpenEye OPTIX PRE-PACK ---		VIEW ANGLE SETUP
		FLIP (ON/OFF)	: ON
HOME
		OVER TILT (ON/OFF)	: OFF
SYS INFO	AREA TITLE	PAN LIMIT (ON/OFF)	:
DISPLAY	PRIVACY ZONE	PAN RIGHT LIMIT	:
DOME SETUP	OSD DISPLAY
		PAN LEFT LIMIT	:
ALARMS	VIEW ANGLE
		MIRROR/REVERSE	: OFF
CAMERA	POSITION
	COOLER/HEATER
CONFIG

LANGUAGE	SAVE EXIT
EXIT

Flip - Allows the dome camera to automatically turn 180 degrees when the camera tilts to its lower position. Once the camera reaches the floor along a moving object, it willstop.

Over Tilt - The defaut limit is 80 degrees for TiIt angle. When this mode is on, you can see up to 90 degrees.

PAN LIMIT(ON/OFF): Off - When the dome camera is installed near the wall, PAN LIMIT can be programmed by user to avoid the area obsured by the wall.

MIRROR/REVERSE: Off - Normal image, H - MIRROR: Left-right reversal of the image, V-MIRROR: Upside down

image, REVERSE: Left - right reversal and Upside down.

E. POSITION

If the OpenEye OPTIX OSD is obsured on other equipment, like a DVR, you can move the OSD horizontally and/or vertically. The factory position is 33/05 (Horizontal/Vertical). Variable 23~43 for horizontal, 02~15 for vertical.

--- OpenEye OPTIX PRE-PACK ---			OSD POSITION SETUP
		HORIZONTAL POSITION		:33
HOME
		VERTICAL POSITION		:05
SYS INFO	AREA TITLE
DISPLAY	PRIVACY ZONE
DOME SETUP	OSD DISPLAY	SAVE EXIT
ALARMS	VIEW ANGLE
	POSITION
CAMERA			WARNING
	COOLER/HEATER
CONFIG		THIS FEATURE AFFECTS
LANGUAGE		PRIVACY ZONE
EXIT

27104AF 29