I I I . I N S T A L L A T I O N
4.Connect the short black (ground) wire to a clean, bare metal area of the vehicle using the 12 mm (1/2 in.) sheet metal screw provided. Mount to an area close to the base of the lift. This allows adequate slack in the wire to make the harness connections.
"Drill a
"Insert the screw through the ring at the end of the black (ground) wire and install the screw into the pilot hole.
WARNING! DO NOT attach the black (ground) wire to the lift.
5.Connect the harness of wires leading to the battery and ground to the harness that extends from the motor housing (black to black and red to red).
MOTOR HOUSING
BLACK - RED
POWER
BLACK (GROUND) WIRE ATTACH TO CLEAN, BARE METAL IN CLOSE PROXIMITY TO LIFT
FUSE
HARNESSES
SHEET METAL SCREW
12 MM (1/2”)
ROUTE RED (+) POWER WIRE | CONNECTOR | AUTOMOBILE |
TO BATTERY | (USE PLIERS OR CRIMPING | BATTERY |
| TOOL TO CRIMP) |
|
Figure 12. Electrical Wiring Connections
SilverBoom 130 | 13 |
