I I I . I N S T A L L A T I O N
7.Place the
8.Reinstall the upper post.
9.Reinstall the motor housing and make adjustments as necessary.
The lift is now fully assembled. See figure 11.
PHILLIPS HEAD SCREW |
10 MM |
Figure 10. L-Base Cap
MOTOR HOUSING |
UPPER POST |
Figure 11. Fully Assembled Lift
ELECTRICAL WIRING INSTALLATION
1.Route the lift’s long red positive (+) power wire (starting at the lift) through the interior of the vehicle until you reach the automobile battery. See figure 12. Conceal the wire behind or under the interior panels (there should be existing holes). Be certain that the wire is protected with a rubber grommet when passing it through the metal panels and into the engine compartment. Inside the engine compartment, secure the wire to the firewall and the inner fender with the supplied plastic wire ties. Use care not to cause abrasions to the power wire. It is important to secure the power wire at various points along its run.
WARNING! The red positive (+) wire must be connected directly to the positive (+) battery terminal.
2.Connect the short portion (with fuse) of the red positive (+) power wire to the positive (+) battery terminal.
3.Insert the end of the long portion of the red power wire into the yellow connector of the short portion and crimp it securely. Once crimped, pull on the wire gently to ensure a good connection. Wrapping the connector with electrical tape will help prevent moisture from corroding the connection.
12 | SilverBoom 130 |
