Note:
When the LCD display shows “CONFIRM CLEAR” you can stop the deletion with the EXIT button y.
Macro Setup
With the MACRO function up to 16 button commands can be carried out with the press of a single button, that is to say, several previously saved control commands can be deleted with one MACRO button. There are 6 Macro memory slots available for you.
To programme a Macro
For Macro programming proceed as follows:
1.Hold down the S button r for a little longer than 3 sec- onds. The notice "CODE SETUP" appears.
2.With the or button t select "MACRO SETUP" and confirm with the OK button l. In the display "MACRO SETUP 1" appears.
3.With the or button t select the memory slot to be programmed (MACRO SETUP 1 - 6) and confirm with the
OK button l.
4.In the LCD display q "MACRO STEP" appears. Now press, one after the other, the desired buttons (max. 16). The sequence should begin with a device button e.
5.By default the Macro commands are sent in intervals of 1 every second. Since many devices react sluggishly it is possible that the sequence of the Macro commands are sent too quickly to the device. Then you have the option of programming, before a button command, a pause of between 5 - 21 seconds. For this purpose press, if nec- essary repeatedly, the MACRO button i. Below
and to the right the LCD display q shows the current pause length in seconds.
6.When the maximum number of button commands is reached the LCD display q shows "FULL".
7.Save the entry with the S button r. In the LCD display q "MACRO SETUP" appears.
8.If, with the selection of the Macros to be programmed (step 3), you select a memory slot that is already occupied the existing Macro will be overwritten.
9.Repeat the process from step 3 to create further Macros.
10.With the EXIT button y you move a level upwards in the menu except during the entry of the button commands.
Tips:
1.A maximum of 16 button commands can be saved in a Macro. After input of the 16th button command, “FULL” appears in the LCD display q.
2.To exit the mode without saving allow approx. 15 sec- onds to pass without an entry.
3.In the mode "MACRO STEP" you can only return to the previous status with the S button r.
- 20 -
