SECTION CHECKLIST
Starting and Stopping the Engine
Tilling
Operation
CAUTION
Always put the depth regulator lever in the transport position before starting engine.Tines should clear the ground.
PRE-START INSPECTION
1.Make sure all safety guards are in place and all nuts and bolts are secure.
2.Check oil level in engine crankcase. See your engine manual for procedure and specifications.
3.Inspect air cleaner for cleanliness. See your engine manual for procedure.
4.Check the fuel supply. Fill the fuel tank no closer than 1 inch from top of tank to provide space for expansion. See your engine manual for fuel recommendations.
5.Be sure spark plug wire is attached and spark plug is tightened securely.
6.Check position of wheels and wheel lockouts.
7.Check depth regulator lever position.
CAUTION
Please do not start your tiller until you have read the Manual that came with your engine, and the sections in this manual titled Controls, Adjustments and Safety. If you have read these, follow the steps below to start your tiller. Always perform this
CAUTION
Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is hot or running. Always move outdoors to fill the tank.
CAUTION
Wheels must always be locked in the TILLING position when engine is running. Do not operate the tiller with the wheel lockouts unlocked. Always set the wheels in tilling position before starting engine.
ENGINE IS SHIPPED FROM FACTORY WITHOUT OIL. YOU MUST ADD ENGINE OIL BEFORE STARTING ENGINE.
STARTING AND STOPPING THE ENGINE
NOTE: Refer to engine manual for proper operating instructions.
CAUTION
Always keep hands and feet clear of rotating machine parts.
CAUTION
Temperature of muffler and near by areas may exceed 150° F. Avoid these areas.
CAUTION
Do not move choke control to CHOKE to stop engine. Backfire or engine damage may occur.
To stop the engine at any time, move throttle control to the off position. To stop wheels and tines at any time, release drive safety control levers to neutral position.
Page 13
