Setup Guide
Dual Stage Snow Thrower
Mfg. No.
1695734, 1695735, 1695820, 1695821, 1695824, 1695825, 1695826, 1695827, 1695843, 1695853, 1695906, 1695908, 1695964
WARNING: Always wear safety glasses or eye shields | E |
when assembling the snow thrower. |
Handle Assembly
1. Carefully unfold the handle while guiding the speed control rod over the tire before cutting the orange ties.
2. Raise the upper handle (A, Figure 1) to the operating |
|
| G |
| ||
position. |
|
|
|
|
| |
NOTE: Make sure the Z fittings at the ends of the cables are |
|
|
| |||
secured in the holes on the control levers. Make sure |
|
|
| |||
the cables are not caught between the upper and lower |
|
|
| |||
handle. |
| Reproduction |
| |||
|
|
| ||||
3. Insert two bolts (B) into lower holes and fasten with two |
|
|
| |||
lock washers and wing knobs (C) or nuts (if equipped). | H | D | F | |||
Tighten all four fasteners securely. |
|
| ||||
|
|
|
|
| ||
4. Use the supplied ties to secure the EZ Steer™ cable (if | Figure 2 |
|
| |||
equipped) to the left handle and the wire harness to the |
|
| ||||
right handle. |
| orf |
|
|
| |
|
|
|
|
|
| |
|
|
|
| Install the Chute Control Rod |
| |
A | Not |
| NOTE: Some models have the chute control already installed. | |||
B |
|
| M els with an electric chute do not have a control rod. | |||
|
|
| 1. Insert the chute control handle (if equipped) through the | |||
|
|
|
| |||
|
|
| B | opening in the upper handle control panel. | ||
|
|
| 2. Insert the end of the chute control rod (I) into the uni- | |||
|
|
|
| |||
|
|
|
| versal joint assembly (J) located next to the chute gear. | ||
|
|
|
| Secure with hair pin (K). |
| |
|
| C |
|
|
|
|
Figure 1 |
|
|
|
|
| K |
|
|
|
|
|
| |
Install the Speed Control Rod |
|
|
|
| I | |
|
| J |
|
| ||
Attach the ball joint (D, Figure 2), located on the bottom end |
|
| ||||
of the speed control rod (E), to the shift yoke assembly (F) | Figure 3 |
|
| |||
with 5/16” lock washer (G) and 5/16” nut (H). Tighten nut |
|
| ||||
|
|
| ||||
securely. |
|
|
|
|
|
|
Copyright Briggs & Stratton Corporation | 1739435 (Rev. B) |