Section 2 - OPERATING INSTRUCTIONS
2.2.4. STOPPING
Stop the auger by releasing the auger control. Stop the engine by turning the key switch to the “OFF” position. Always remove key from key switch
before leaving machine unattended. See Figure 2.7.
RELEASE AUGER
CONTROL TO
STOP AUGER
1.Connect the power cord to the starter switch box on machine’s control panel then plug the other end into 120 volt AC receptacle.
2.Turn ignition key to the “ON” position.
3.Move choke control to the choke “ON” position. See Figure 2.8.
4.Push primer button three times to start a cold engine. NOTE: Do not use primer button to start warm engine.
5.Push the electric starter button. DO NOT hold button for more than 20 seconds to avoid damaging the starting motor. See Figure 2.8.
6.After engine starts, move the choke control to the no choke “OFF” position. Allow a brief
7.Disconnect power cord from AC receptacle. Disconnect power cord from machine and remove cord from area where machine will be in operation.
NOTE: Stop the auger by releasing the auger control. Stop the engine by turning the key switch to the “OFF” position.
TURN KEY TO THE “OFF”
POSITION TO STOP ENGINE
FIGURE 2.7
2.2STARTING, STOPPING & OPERATION (ELECTRIC START MODELS)
2.2.5. ENGINE & AUGER
PUSH PRIMER
THREE TIMES
INSERT POWER CORD
INTO STARTER BOX
(SHOWN IN “OFF POSITION) MOVE CHOKE TO THE “ON” POSITION
(SHOWN IN “OFF POSITION) TURN KEY TO THE “ON” POSITION
PUSH STARTER
BUTTON
WARNING
DO NOT use an electrical extension cord that is damaged. A damaged electrical extension cord could cause a shock or fire. Thoroughly inspect electrical extension cord before using machine. If cord is damaged, do not use and do not operate machine. Replace damaged cord immediately. Contact your authorized servicing dealer for assistance. To reduce the risk of electric shock, use only with an extension cord intended for outdoor use having a cord type:
FIGURE 2.8
8
