Controls
DRIVE SAFETY CONTROL LEVER
Engage tines into forward, releasing returns machine to neutral.
!CAUTION
Pulling down on drive safety control lever engages the tines. Releasing | THIS INFORMATION IS PROVIDED HERE ONLY TO | |||||||
INTRODUCE THE CONTROLS. DO NOT START THE | ||||||||
the drive safety control lever disengages the tines to a neutral | ||||||||
ENGINE AT THIS TIME. STARTING AND OPERATING | ||||||||
position. |
|
|
|
|
| |||
|
|
|
|
| INSTRUCTIONS ARE GIVEN ON PAGE 10. PLEASE | |||
BELT TENSION ADJUSTMENT |
|
|
| |||||
|
|
| READ THIS SECTION AND ALL OPERATING AND | |||||
Proper belt tension is critical to good performance. After 1/2 hour of | SAFETY INSTRUCTIONS BEFORE STARTINGYOUR | |||||||
TILLER. | ||||||||
operation, all cables may have to be adjusted due to initial stretch. | ||||||||
s AS A SAFETY PRECAUTION,THE DRIVE SAFETY | ||||||||
Thereafter, check tension after every 2 hours of operation. |
|
| ||||||
To increase belt tension: |
|
|
|
|
| CONTROL LEVER WILL NOT LOCK IN THE | ||
|
|
|
|
| FORWARD POSITION. | |||
|
|
|
|
|
|
| ||
1. | Loosen upper jam nut. Turn nut up cable in 1/8” increments. | s TO STOP THE WHEELS AND TINES AT ANY TIME | ||||||
|
|
|
|
|
|
| ||
2. | Tighten lower jam nut. |
|
|
|
|
| RELEASE THE DRIVE SAFETY CONTROL LE- | |
3. | Check adjustment. |
|
|
|
|
| VER. | |
|
|
|
|
|
| |||
This procedure can be repeated until conduit adjustment bolts have |
| |||||||
no more adjustment left. If no more adjustment can be made, belt | ! WARNING | |||||||
may have to be replaced. |
|
|
|
|
| |||
DEPTH REGULATOR LEVER | Reproduction | |||||||
| depth. |
|
|
|
| for | ANY CONTROLS. | |
Tilling depth is controlled by the height of the depth regulat | r lever. | DO NOT ADJUST TILLING DEPTH UNLESS DRIVE | ||||||
To adjust tilling depth. |
|
|
|
|
| SAFETY CONTROL LEVER IS RELEASED TO THE | ||
1. | Remove detent pin. |
|
| Not |
| NEUTRAL POSITION. | ||
2. | Raise the depth regulator lever to position tines at chosen illing |
| ||||||
3. | Align hole in depth regulator lever with h le in depth regulator |
| ||||||
| bracket and replace detent pin. |
|
|
|
|
| ||
| drive safety control lever disengaged |
|
|
| ||||
|
| 1/4” stretch |
|
|
| |||
|
|
| upper jam nut |
|
|
| ||
|
|
| lower jam nut |
|
|
| ||
|
|
|
| forward cable |
|
|
| |
| Model 5521 Handlebar |
|
|
| ||||
9