Simplicity 5600079, 200-7302-00-CI-S, 5100777 Installation Instructions, Kit Part No

Installation Instructions Kit Part No. 5600079

9.Loosely install the rear brackets (F, Figure 6) to the new front end with the 3/8-16 X 1-1/4” bolts (C), 3/8- 16 X 3-1/2” bolts (B), 3/8 SAE washers (D), and 3/8- 16” nylon flange nuts (E). Snugly clamp the front of the new front end to the cross member using (2) C- clamps (See Figure 7).NOTE: Do not over tighten the clamps.

9.Snugly clamp the top of bracket and the bottom of the new front end to the frame rail using (2) more C- clamps. Tighten the bottom bracket bolts. Refer to Figure 8. Using the front top hole as a guide drill a 3/8” hole through the frame and install 3/8-16 X 2- 1/2” bolts and 3/8-16 flange nuts on both sides of the frame. Tighten the bracket hardware (Do Not Exceeds 35 ft lbs of Torque) and remove clamps that were holding it.

10.Drill the front mounting holes: Use the holes in the new front end as guide, drill the top holes from the top and the bottom holes from the bottom to insure the correct alignment. Install 3/8-16 X 3-1/2” bolts (A, Figure 6) and 3/8-16 flange nuts (E, Figure 6). Tighten the hardware and remove the clamps.

E B

D

A

E

F

D

C

Figure 6. Loosely Install the Rear Brackets

A.3/8-16 X 2-1/2 Bolt

B.3/8-16 X 3-1/2 Bolt

C.3/8-16 X 1-1/4 Bolt

D.3/8” SAE Washer

E.3/8-16 Nylon Flange Nut

F.Rear Bracket

Figure 7.	C-Clamp Positions
Bottom of Frame			Top & Side
		Drill Holes
	FRONT	Here	FRONT
Figure 8.	Drill 3/8” Holes

		5100777
	3	Rev. 07/2006
© Copyright 2006 Ferris Industries. All Rights Reserved.		TP 200-7302-00-CI-S