Installation Instructions | Kit Part No. 5600079 |
7.Install the plastic end caps (B, Figure 4) in the ends of the cut cross member (A) and the new front end
(C).
A |
B |
C |
Figure 4. Install Plastic End Caps
A.Cut Cross Member
B.Plastic End Cap
C.New Front end
8.Position from the bottom the new front end against the frame as shown in Figure 5. Then slide toward the rear of the machine until the
new front end rests over the front cross member that was cut.
Figure 5. Install New Front end
|
| 5100777 | |
| 2 | Rev. 07/2006 | |
© Copyright 2006 Ferris Industries. All Rights Reserved. | TP | ||
|
