Simplicity Comprehensive Guide for 1060 Snow Blower Traction Drive Group

Traction Drive Group

NOTE: Unless noted otherwise, 986712

use the standard hardware torque specification chart.

2

1

1

Mounted outside of frame.

		Mounted inside of frame.							Pack groove
		3											13
									with grease.
		4	Lubricate with										12
			5W 50 Synthetic oil.								11		Hook end to
			5		6	Mount to bracket in				10			top left corner
						frame weldment.							slot of frame.
						7							14
2		Apply loctite						8
		(2 places).
	3
		20
												Apply Loctite and•
		21							9
												Torque to 55 - 60
										18		in-lbs. when all parts
												are against hub.
			23			15					19		Mounted outside
				24
													of frame.
							16
								15	17
													1
						25	27		8
		22									30		3
		Grease I.D. teeth•		26							31
													2
		and flange.

32

3

							1
Be sure tie bar support is in place. Move axle to				28
left (as viewed from back) to take up end play.
Move set collar (Ref. 49) to right to remove end				29
play in pivot arm (Ref. 40). Torque set screw
					20
(Ref. 43) to 10 - 14 ft-lbs.						Mounted
48					2	outside of
				40		frame.
				41	33		Mount in
49							hole at
Apply grease to					Must pivot		upper rear
							corner of
			43		freely.
bearing areas.
				42			frame.
	44					34
			45
	46
							35
					39
50					38
Torque to•						37
18 - 21 ft-lbs.					55
	52				38		36
					56
	47
	50				Apply anti-seize
	Torque to		46		compound to wheel hub
	10 - 14 ft-lbs.
		53			area of Ref. 49 & 57.
Assemble Ref. 40, 44 & 51	51					58
							59
with no end play. Parts
must rotate freely.			33	26
				54	Grease bearing
				57	area of Ref. 57.

The above parts group applies to the following Mfg. Nos.:

1694589	- 9560E	1694598 - 1060M
1694590	- 1060E	1694599 - 1170M
1694591	- 1170E	1694600 - 1280M
1694592	- 1280E	1694601 - 1390M
1694593	- 1390E
1694597	- 9560M

© Copyright 2005 Simplicity Manufacturing, Inc. All Rights Reserved. 30 TP 400-4155-01-LW-S