Sinclair ASH-24CN Install the outdoor unit, Install the connection pipe, Tightening torque table

Install the outdoor unit

Install the connection pipe

1.Align the center of the piping flare with the relevant valve.

2.Screw in the flare nut by hand and then tighten the nut with spanner and torque wrench refer to the diagram at right.

Note: Exceeding tightening torque will damage the flare surface.

Tightening torque table

Hex nut diameter (mm)	Tightening torque (N.m)
6	15~20
9.5	31~35
12	50~55
16	60~65

Torque wrench

Spanner

Nut ofJoint connection pipe

Fig.7

Electric wiring connection

1.Remove the front side plate (Fig.8)

2.Break through the hole for wires and put on rubber bush. 3.Pull all wires throught the rubber bush.

4.Remove the wire clamp and connect the end of the power connection cord with screws to the wiring terminal board according to the “WIRING DIAGAM” of outdoor unit.

5.Make sure that the wiring has been connected firmly. 6.Tighten the wire with clamp and clasp.

control cord

5 0 . 7 5

(for CE stander5 1.0 )

	red
blue
brown	yellow-green
wire clamp	power supply cord
heat pump type only

hole

front side plate

rubber bush

power connection cord

control cord

Fig.8

Wire clamp

NOTE:

Wrong wiring connection will cause electrical mal-

function.

Do not pull the wire when fixing it with wire clamp.

Do not let the wire too loose in the outdoor unit.

Wire clasp

2 6