Singer 3323 instruction manual Side Cutter

￿￿Side Cutter

Lift the presser foot lifter (a) to raise the presser foot bar. (1)

Remove the presser foot. (See page 49)

Attach the Side Cutter to the machine as follows (2):

-Insert the arm (b) to the needle clamp (c).

-Lower the presser foot lifter while making sure the pin (d) of the side cutter fits the presser shank (e) and is secured in place.

Cut an edge of fabric about 2~3 cm. (3)

Put fabric on guide plate (f) and push left side of the fabric to go below presser foot (g). (2/4)

Thread the needle and pull back upper and lower threads under presser foot and put them to the direction of feeding.

Run machine slowly and start sewing from the below of the needle.

Adjust the stitch width and the stitch length according to stitch selected.

For very thin fabric, loosen the tension of upper threads as well as the pressure of presser foot shank. Guide the fabric by your finger not to slide aside.

Note:

The side cutter can only be used with the regular zigzag stitch or the overlock stitches.

		￿
	￿
		￿
	￿	￿
	￿	￿
1	2

	2~3 cm
3	4

￿￿