Sirius Satellite Radio SDSV6V1 manual Vehicle Installation, Convertible

Vehicle Installation

or controls.. Secure the excess cable with wire ties (purchased separately)..

4.Bring the end of the cable out at the PowerConnect Vehicle Dock location.. Leave yourself enough cable so you can easily connect it to the antenna connector of the dock..

5.Continue with “Step 5: Connect the Magnetic Mount Antenna and PowerConnect Power Adapter” on page 39..

•Convertible:

1.Bring the antenna cable from the antenna into the trunk at the front edge of the trunk lid.. Keep any bends in the cable loose.. Tape or tie the cable along the inside of the trunk lid to the trunk lid hinge strut..

2.Allow enough slack in the cable so the trunk lid can easily open and close and keep the cable away from hinges, gears, etc.., that could crimp or cut it.. Route the cable along the trunk wall and into the cabin through a conduit or along an existing wiring harness..

3.Route the cable through the

main cabin area under the interior trim, towards the front of the vehicle.. Use a blunt plastic putty knife or similar blunt tool to lift the plastic trim just enough to tuck the cable under underneath.. Avoid side airbag locations on back pillars and above the doors..

36