Sirius Satellite Radio SP-C1 manual Installation in a Vehicle Running the Antenna Cable

Installation in a Vehicle: Running the Antenna Cable

1.Turn the SP-R1 receiver power OFF and remove it from the cradle; unplug the Car Power Adapter from the cigarette lighter; unplug the antenna from the cradle.

2.Route the cable from the antenna to the vehicle’s interior by tucking it underneath the rubber molding around rear window, as shown below.

3.Route the cable from the lowest point of the rear window into the trunk. Take advantage of any existing cable channels or wiring conduits.

•For SUVs, minivans & 5-door vehicles, bring the cable into the vehicle under the rubber molding for the tailgate, and continue under the interior trim.

4.From the trunk, route the cable around the passenger compartment and to the back of the cradle.

•Do not pull the wire across sharp edges that could damage it.

•Keep the wire away from areas where it could become tangled in driver’s and passenger’s feet.

5.Plug the antenna into the back of cradle where it says “ANT”.

6.Plug the car power adapter into the cigarette lighter.

IT IS RECOMMENDED THAT YOU UNPLUG THE CAR POWER ADAPTER AFTER THE VEHICLE’S IGNITION IS TURNED OFF.

	7
Sportster SP-C1 User Guide