Sirius Satellite Radio SRS-2VB Cable Installation, Antenna Pod, Adjustment, Screw

SKY

HORIZONTAL LEVEL

Antenna Pod

1

2	Adjustment
	Screw

Adjustment

Screw

Slightly loosen the adjustment screws and position the antenna so that the top of the antenna pod is level, with the top of the pod horizontal to the sky as shown. When the antenna is adjusted correctly, tighten the adjustment screws but be careful not to overtighten them.

Continue with the next section for installations with exposed wiring, or the section following for installations with hidden wiring.

Cable Installation

Once the antenna is mounted according to the previous instructions, you can continue with the cable and Splitter portion of the installation:

1.Take the RG-6 cable which you purchased to connect to the antenna and thread one end of the cable through the opening in the end of the rubber boot. Then connect the cable to the antenna pod as shown in the illustration following.

2.Slide the rubber boot over the cable connection to provide a weather proof seal and install the cable tie around the cable directly below the rubber boot to prevent the rubber boot from slipping down. Trim off the excess cable tie.

3. Route the remainder of the antenna cable into the home or building to where

12 Home Distribution Kit Installation Manual