TEMPLATES
Using template patterns lets you duplicate
designs or letters uniformly time after time.
This technique requires the use of an
template guide adapter and a template guide.
TEMPLATE GUIDES
(Not included, available as accessory)
The template guide shown in (Fig. 18), is
essentially a plate with a collar which is
inserted through the hole in sub-base and
template guide adapter from below and
fastened with a knurled retaining nut. The
template guide rides along the edge of the
templat while the router bit, protruding below,
cuts into the work.
ATTENTION: Be sure the thickness of the
templat is the same or larger than the guide
surface of the collar.
Do not use a bit that may touch the inside of
the collar. Select a bit that is about 1/16" less
in diameter.
Template guides are used with a number of
special accessories, such as hinge
templates, which are listed in your Skil
catalog.
In addition, special templates are easily
prepared for cutting repeated patterns,
special designs, inlays, and other
applications. A template pattern may be
made of plywood, hardboard, metal or even
plastic, and the design can be cut with a
router, jigsaw, or other suitable cutting tool.
Remember that the pattern will have to be
made to compensate for the distance
between the router bit and the template
guide (the “offset”), as the final workpiece
will differ in size from the template pattern by
that amount, due to the bit position (Fig. 19).
TEMPLATE GUIDE
(optional accessory)
TEMPLATE GUIDE
ADAPTER
(optional accessory)
FIG. 18
COLLET CHUCK
WORKPIECE
ROUTER BIT
OFFSET
TEMPLATE
GUIDE
TEMPLATE
PATTERN
FIG. 19
ROUTER
SUB-BASE
ROUTER
SUB-BASE
PILOT TIPPED AND BEARING GUIDE BITS
The lower portion of a pilot tipped bit, as
shown in (Fig. 17), is a shaft with no cutting
edges. Bearing guide bits have a ball bearing
to pilot the bit.
This pilot slides along the edge of the work as
the rotating blades make the cut, forming
molding or decorative edges. The edge on
which the pilot slides should be perfectly
smooth since any irregularities are transferred
to the shaped surface.
-14-
PILOT SLIDES
ALONG EDGE
OF WORK
CUTTER PART OF
PILOT TIPPED BIT
CUT
FIG. 17
KNURLED
NUT
BM 1619X00324 3-04 3/16/04 2:13 PM Page 14