SM 1619X00551
*BATTERY CHARGED CONDITION INDICATOR
The battery is equipped with a charged condition indicator (Fig.1). The indicator lights show the charged condition of the battery during the working process.
By pressing the battery fuel indicator button, the charged condition can be checked. Note: to check charge level, the battery must be in the tool.
•• • When all three lights are illuminated, this indicates the battery pack is fully charged.
•• When only two lights illuminate, this indicates the battery pack is partially charged.
•When only one light illuminates, this indicates the battery pack is slightly charged.
When no lights illuminate, this indicates the battery pack is completely discharged.
DRILL BIT AND SCREW STORAGE
COMPARTMENT
Your tool is equipped with a handy bit and screw storage compartment in the housing of your tool (Fig. 3).
To open, simply lift up lid at tab.
The storage will allow you to conveniently store bits and screws.
To close, lower lid until it locks in place.
LID
FIG. 3
*DRILL BIT STORAGE COMPARTMENT AND QUICK REFERENCE GAUGE
Your tool may be equipped with a bit storage compartment and quick reference gauge located on top of your tool.
To remove, simply slide off the housing towards the back of the tool.
The quick reference gauge will allow you to identify the size of drill bits, and standard or metric screws.
Hex bits can be slid in from the front for storage.
FIG. 4
BIT STORAGE | QUICK REFERENCE |
COMPARTMENT | GAUGE |
* STUD FINDER
Your tool may be equipped with a stud finder located on top of your tool.
To remove, simply slide off the housing towards the back of the tool.
Before first use, open the battery compartment door and remove the protective plastic insert from between the batteries. Assure proper battery placement as shown in the compartment and replace the door (Fig. 5). Your stud finder uses four L1154 button cell batteries.
FIG. 5 | DOOR |
|
BATTERIES
PROTECTIVE
PLASTIC INSERT
