SM 1619X00551
To use, place stud finder flat against the wall with LEDS pointing up. Be sure to keep your fingers below the line on the stud finder to avoid false readings (Fig. 6).
FIG. 6
RED LED
The yellow LED indicates you are approaching a stud.
The red LED indicates stud edge. Mark this spot.
With the button still depressed, continue sliding the stud finder in the same direction until the red LED turns off. This is the studs
GREEN LED
YELLOW LED
BUTTON
other edge. Mark this spot.
The midpoint of the two marks is the center of the stud.
LINE
Push and hold button to calibrate and activate unit (Green LED) (Fig. 6). Slowly slide unit horizontally across the wall without picking up or tilting.
A fault has occurred when all three LEDS flash . To correct, simply restart the circuit.
!WARNING Stud finders can detect other objects besides
studs, such as electrical wiring and metal/plastic pipes. Contact with a “live” wire will make exposed metal parts of the tool “live” and shock the operator.
(Studs are normally spaced 16 or 24 inches apart and are
CHARGING BATTERY PACK (3 HOUR CHARGER)
Plug charger cord into your standard power outlet. Before inserting battery pack, remove protective cap, then insert battery pack into charger (Fig. 7).
The charger’s green light (Fig. 8), will turn “ON”. The green light remains ‘‘ON’’ as long as charger is plugged in, and does not shut off.
After normal usage, the battery pack requires approximately 3 hours or less charging time to become fully charged. If the battery pack
is
When the battery pack is fully charged, unplug the charger (unless you're charging another battery pack) and slip the battery pack back into the tool handle.
To prevent fire or injury when batteries are not in tool or charger, always place protective cap onto end of battery pack.
FIG. 7 |
| FIG. 8 | CHARGER |
INDICATOR
LIGHT
PROTECTIVE
CAP
BATTERY PACK
